[ltp] ipw2200 Suse 10 no link on TP42p

[Andreas Siegert]

Hi,

been using my TP42p happily with SuSE 9.3,
since I switched to SUSE 10, I see no link in kwifimanager and other
monitoring tools (wmwave), the link bar pops up when reconfiguring 
the interface, but that's it. 
This is what I get from iwconfig:

eth1      IEEE 802.11b  ESSID:"Dahoam"  
          Mode:Managed  Frequency:2.457 GHz  Access Point: 00:50:F8:06:7E:FE   
          Bit Rate=11 Mb/s   Tx-Power=20 dBm   
          Retry limit:7   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=0/100  Signal level=-64 dBm  Noise level=-84 dBm
          Rx invalid nwid:0  Rx invalid crypt:25  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:4   Missed beacon:97

Any ideas wehere to look?

thx
afx

-- 
atsec information security GmbH                Phone: +49-89-44249830
Steinstrasse 70                                  Fax: +49-89-44249831
D-81667 Muenchen, Germany                        Web: atsec.com
                      May the Source be with you!