[ltp] turbo 16/4 pc card problem in 2.2.18

[linux-thinkpad@www.bm-soft.com]

In linux 2.2.18, ibm turbo 16/4 pc card is not working properly in my 380ED
ibm thinkpad. Pcmcia pakage version is 3.1.22. This the the dmesg. .




Linux version 2.2.18 (root@localhost) (gcc version egcs-2.91.66
19990314/Linux (egcs-1.1.2 release)) #3 SMP Sun Dec 17 11:10:37 IST 2000
mapped APIC to ffffe000 (0025c000)
Detected 167047 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 333.41 BogoMIPS
Memory: 14420k/16384k available (1048k kernel code, 424k reserved, 420k
data, 72k init)
Dentry hash table entries: 2048 (order 2, 16k)
Buffer cache hash table entries: 16384 (order 4, 64k)
Page cache hash table entries: 4096 (order 2, 16k)
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
Intel Pentium with F0 0F bug - workaround enabled.
POSIX conformance testing by UNIFIX
per-CPU timeslice cutoff: 1.55 usecs.
CPU0: Intel Pentium MMX stepping 03
SMP motherboard not detected. Using dummy APIC emulation.
PCI: PCI BIOS revision 2.10 entry at 0xfd8a0
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (ehash 16384 bhash 16384)
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
pty: 256 Unix98 ptys configured
hda: TOSHIBA MK2103MAV, ATA DISK drive
hdb: HITACHI CDR-S100, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: TOSHIBA MK2103MAV, 2016MB w/128kB Cache, CHS=1024/64/63
hdb: ATAPI 20X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.11
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
scsi : 0 hosts.
scsi : detected total.
Partition check:
 hda: hda1 hda2 hda3 < hda5 hda6 hda7 > hda4
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 72k freed
Adding Swap: 92696k swap-space (priority -1)
Linux PCMCIA Card Services 3.1.22
  kernel build: 2.2.18 #3 SMP Sun Dec 17 11:10:37 IST 2000
  options:  [pci] [cardbus] [pnp]
PnP: PNP BIOS installation structure at 0xc00fe700
PnP: PNP BIOS version 1.0, entry at f0000:e724, dseg at f0000
Intel PCIC probe:
  Cirrus PD6729 rev 00 PCI-to-PCMCIA at slot 00:13, port 0x3e0
    host opts [0]: [ring] [1/6/16] [1/20/16]
    host opts [1]: [ring] [1/6/16] [1/20/16]
    ISA irqs (default) = 3 polling interval = 1000 ms
cs: IO port probe 0x0a00-0x0aff: clean.
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0300-0x04ff: clean.
cs: IO port probe 0x0100-0x02f0: clean.
cs: memory probe 0x0c0000-0x0cffff: excluding 0xc0000-0xc7fff
cs: memory probe 0x0d0000-0x0dffff: clean.
tr0: ISA P&P 16/4 Adapter/A (short) | 16/4 ISA-16 Adapter found
tr0: using irq 3, PIOaddr a20, 64K shared RAM.
tr0: Hardware address : 00:06:29:F4:85:BD
tr0: Shared RAM paging disabled. ti->page_mask 0
tr0: Maximum Receive Internet Protocol MTU 16Mbps: 16344, 4Mbps: 6104
tr0: Initial interrupt : 4 Mbps, shared RAM base 000d4000.
tr0: port 0xa20, irq 3, mmio 0xc00c9000, sram 0xd4000,
  hwaddr=000629F485BD
tr0: Opening adapter: Xmit bfrs: 1 X 264, Rcv bfrs: 264 X 264
tr0: Initial interrupt : 4 Mbps, shared RAM base 000d4000.
tok_open: returned with open_status==CLOSED
tr0: Opening adapter: Xmit bfrs: 1 X 264, Rcv bfrs: 264 X 264
tr0: Initial interrupt : 4 Mbps, shared RAM base 000d4000.
tok_open: returned with open_status==CLOSED


Please help me with the problem

regards,
Shiju


----- The Linux ThinkPad mailing list -----
The linux-thinkpad mailing list home page is at:
http://www.bm-soft.com/~bm/tp_mailing.html