[ltp] eth0 not present.

[Tom French]

MORE INFO:

iwconfig etho
eth0     IEEE 802.11-DS ESSID:"858015GROUP"  Nickname:"starlog.MAITLAND"
            Mode:Ad-Hoc   Frequency:2.437Ghz   Cell:00:00:00:00:00:00
           Bit Rate:2Mb/s     Tx-Power=15 dBm    Sensativity:1/3
          RTS thr:off       Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality:0    Signal level:0    Noise level:0
          RX invalid nwid:0   invalid crypt:0   invalid misc:0

Thanks





----- Original Message -----
From: "Eric Jorgensen" <alhaz@xmission.com>
To: <linux-thinkpad@www.bm-soft.com>
Sent: Tuesday, July 02, 2002 11:11 PM
Subject: Re: [ltp] eth0 not present.


> On Tue, 2 Jul 2002 21:47:47 -0400
> "Tom French" <tfrench1@cfl.rr.com> wrote:
>
> >
> > Hello, here is my problem now:
> >
> > I cannot get the eth0 setup so the wvlan_cs card will attach.
> > I have a Thinkpad 760xl with RH 7.1 and want to get the Buffalo WIFI
card
> > working. The following is what is shown:
>
> <Snip!>
>
> > ifconfig only shows lo, no eth0, and I am not sure if I need it, but the
> > internet gui does not offer wireless.
>
> What's 'ifconfig -a' say?
>
> > So how do I make it connect to my AP.?
>
> You'll need iwconfig.
>
> ----- The Linux ThinkPad mailing list -----
> The linux-thinkpad mailing list home page is at:
> http://www.bm-soft.com/~bm/tp_mailing.html
>


----- The Linux ThinkPad mailing list -----
The linux-thinkpad mailing list home page is at:
http://www.bm-soft.com/~bm/tp_mailing.html