[ltp] modem driver from Smartlink

[Tino Keitel]

On Mon, Feb 17, 2003 at 11:27:28 +0100, Jan Frey wrote:
> On Monday 17 February 2003 11:21, Tino Keitel wrote:
> 
> > > > I managed to hook up the modem to an analog telephone line this
> > > > weekend, tried to dial a number and only got this:
> > > >
> > > > Feb 15 14:14:28 localhost chat[18170]: ATDT0192071^M^M
> > > > Feb 15 14:14:28 localhost chat[18170]: NO DIALTONE
> > > >
> > > > Looks like bad luck for me. :-(
> > >
> > > I had the same problem... for me it was due to a wrong
> > > country setting....
> 
> >
> > I have this line in my modules.conf:
> >
> > options slmdm country=GERMANY
> >
> > Output from minicom:
> >
> > ATI7
> > Country: GERMANY
> > Serial Number: 98638029
> > Protocol Factor: 6ca8fd0
> 
> Well, then.... 
> Are you sure, that your telephone line gets a standard 
> dialtone (no in-house telephone system or something like that)?
> Did you hear the dialtone?

I just plugged the RJ11 connector of my girlfriends phone into the RJ11
interface of the ThinkPad. However, the phone is connected to some kind
of telephone system (to use analog devices on an ISDN line).

When I tried to dial in, I used alsamixer to maximize the volume of
every possible sound source, by I didn't hear the dialtone.

Maybe I can try it again on a "real line" this week.

Regards,
Tino

-- 
tino.keitel@innominate.com
dipl.-inf.                        Innominate Security Technologies AG
software engineer                                   networking people
tel: +49.30.6392-3308                      http://www.innominate.com/